P0716 Code: Input/Turbine Speed Sensor Range — Causes & Fix
P0716 means the transmission input/turbine speed sensor signal is out of range — the sensor that reports how fast the input shaft/turbine is turning.
- Applies to
- All OBD-II vehicles (any make or model)
- Est. repair cost
- $40 – $600
- Time to fix
- 1–4 hours
What it means
Causes include a failed input speed sensor, low fluid, a damaged reluctor, or wiring faults. P0716 is a generic OBD-II code defined in the SAE J2012 standard, so it applies to virtually any 1996-or-newer OBD-II vehicle regardless of make. Fix the underlying fault, then clear the code with an OBD-II scan tool — it will return if the problem isn't resolved.
Symptoms
- Check engine light on
- Harsh, erratic, or slipping shifts
- Possible limp mode
How to fix it
- 1
Check fluid and the sensor
1. Confirm fluid level/condition. 2. Inspect the input speed sensor connector and wiring.
- 2
Test/replace the sensor
1. Verify a clean signal on a scan tool. 2. Replace if faulty, then clear the code.
Frequently asked questions
Can low fluid cause P0716?
Yes — low or aerated transmission fluid can disrupt the input speed reading and shifting. Check fluid before replacing the sensor.
Last updated July 19, 2026
Guidance only — always consult a qualified professional or the official service manual before carrying out repairs.